Return to Todd Walker Home Page
![]()
Reversal Processing for Slides
Jones-Flick Variation, D-67 ...... 1970
DEVELOPER
elon 2.0 grams sodium sulfide 90.0 grams hydroquinone 4.0 grams sodium carbonate 40.0 grams potassium bromide 5.0 grams potassium thiocyanate 2.0 grams water to 1000.0 milliliters Development time:
68 degrees F. 8:00 minutes 72 degrees F. 6:45 minutes 75 degrees F. 6:00 minutes For each roll, 36 exposure, 35 mm, the following replenisher should be added, 30 ml. per roll...
elon 2.0 grams sodium sulfite 90.0 grams hydroquinone 4.0 grams sodium carbonate 50.0 grams potassim bromide none potassium thiocyanate 5.0 grams water to 1000.0 milliliters
BLEACH
water 1000.0 milliliters potassium dichromate 10.0 grams sulfuric acid 12.0 milliliters
CLEARING BATH
water 1000.0 milliliters sodium sulfite 90.0 milliliters
PROCEDURE
Using Pantomic-X film, 35 mm: For flat copying of prints or other material, use an ASA rating of 125. For three dimensional material, use an ASA rating of 160.Develop according to the time/temperature chart above. Replenish stock bottle before returning used developer to bottle.
1.
developer
correct time for temperature 2. bleach 2:00 minutes 3. rinse 1:00 minute 4. clearing bath 1:00 minute 5.
wash
3:00 minutes
After 1 minute, white room light should be turned on.
Film is thoroughly fogged on both sides for at least
30 seconds at a distance of 1 foot from a 100 watt
white light bulb. Be careful not to splash water on the hot bulb.6.
Dektol
(or other print developer)5:00 minutes 7. water or stop bath 1:00 minute 8. fixer 3:00 minutes 9. wash, running water 5:00 minutes 10. dry
Obituary Self-portraits WWII Pilot Resume Commercial Photography Off-site Images Nonsilver Gallery
Photo-silkscreen Gum Prints Van Dyke & Kallitype Reversal Processing Blueprints Inko Dyes Litho Film
TW Scholarship UA Collections Portraits Off-site links Ancestry HOME
Jerry Ferrin.
This page was last updated March 28th, Y2K.